Lift kit with NX2 shocks BDS Lift 4"

• Heavy-duty 1/4-inch steel crossmembers maximize ground clearance, improve strength and offroad capability
• Heavy duty steering knuckles to correct steering geometry and maintain ESC system compatibility
• Top mounted strut spacers to provide lift and install easily
• Differential skid plate for improved offroad protection
• High-strength fabricated lift blocks and u-bolts ensure rear suspension durability and proper stance with tail high appearance
• NX2 Nitro shocks deliver superior dampening for on- and off-road performance
• Accommodates up to 35” tires for a bold, aggressive stance
• NX2 Nitro Series shocks:
  • Nitrogen-charged
  • Twin-tube design
  • 10-stage velocity-sensitive valving
  • Dual-welded ends for increased strength
  • 1-3/8-inch high-flow piston
  • Self-lubricating seals
  • Silver powder coat finish

In the box:

• (2) NX2 shock rear
• Front BDS cross member
• (2) Sway bar drop
• Differential skid plate
• (2) Brake line bracket
• Rear BDS cross member
• (2) Differential drop bracket
• (2) Differential support bracket
• (2) Knuckle
• (2) 4" strut spacer
• (2) Strut preload spacer
• (2) Rear block
• (2) Bump stop extension
• (4) U-Bolt
• Brake line relocation bracket
• Hardware

Notes:

• 18" or larger diameter wheels are required. Stock 17" and 18" wheels cannot be re-installed. Stock 20" wheels can be used with up to a 305/60R20 tire
• 18" wheels with 5-5,5" backspacing should be test fit prior to mounting the tire to ensure proper clearance to the steering knuckle/tie rod. 5,5" backspacing is highly recommended for tire-to-frame crash bar clearance
• Models with 2-piece rear driveshaft will require carrier bearing shim kit BDS122406 (sold separately)
• Block kits replace factory 1-1/4" block. The stock block will not be reinstalled
• Crash bars may require modification based on wheel and tire choice. It is the end user's responsibility to ensure modifications are non-detrimental to vehicle safety
• Some trucks with a 2 piece drive shaft may have a recall from Ford regarding the rear driveshaft. (Safety Recall 21S25) Due to the recall procedure, BDS recommends having this performed prior to installing the lift
• Will not work with models with CCD (Continuous Controlled Damping)
• Requires frame bracket modification
• Will not work with Diesel models
• Will not fit Tremor and Raptor models
• Fits 4WD models only
• Max wheels size:
  • 35 x 12.5 with 20 x 8 and 5.5 in. Backspace Trimming may be required
  • 35 x 12.5 with 20 x 9 and 5.75 in. Backspace Trimming may be required